Suzuki SY413 Service Manual page 4564

0B-6 MAINTENANCE AND LUBRICATION
1. Oil pan
2. Oil drain plug
62G00-0B-6-1S
1 . Oil filter
62G00-0B-6-2S
62G00-0B-6-3S
62G00-0B-6-4S
2
1
62G00-0B-7S
62G00-0B-6-5S
Before draining engine oil, check engine for oil leakage. If any evi-
dence of leakage is found, make sure to correct defective part before
proceeding to following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall drain plug, and
2, (a)
62G00-0B-3S
3) Loosen oil filter by using oil filter wrench (Special tool).
62G00-0B-4S
4) Apply engine oil to new oil filter O-ring.
5) Screw new filter on oil filter stand by hand until filter O-ring contacts
62G00-0B-5S
6) Tighten filter 3/4 turn from the point of contact with mounting sur-
62G00-0B-6S
7) Replenish oil until oil level is brought to FULL level mark on dipstick.
8) Start engine and run it for three minutes. Stop it and wait another
1. Low level mark
2. Full level mark
tighten it securely as specified below.
Tightening Torque
(a): 35 N·m (3.5 kg-m, 25.5 lb-ft)
Special Tool
(A): 09915-47330
mounting surface.
CAUTION:
To tighten oil filter properly, it is important to accurately
identify the position at which filter O-ring first contacts
mounting surface.
face using an oil filter wrench.
Special Tool
(A): 09915-47330
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
(about 5.2 liters or 11.0/7.1 US/Imp pt.). Filler inlet is at the top of
cylinder head cover.
3 minutes before checking oil level. Add oil, as necessary, to bring
oil level to FULL level mark on dipstick.