Suzuki SY413 Service Manual page 4528

AUTOMATIC TRANSMISSION (3 A/T)
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
D Service on and around the air bag system components or wiring must be performed only by an autho-
rized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" under "Gener-
al Description" in air bag system section in order to confirm whether you are performing service on
or near the air bag system components or wiring. Please observe all WARNINGS and "Precautions"
in air bag system section before performing service on or around the air bag system components or
wiring. Failure to follow WARNINGS could result in unintentional activation of the system or could
render the system inoperative. Either or these two conditions may result in severe injury.
D Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system may
be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
NOTE:
For the descriptions (items) not found in this section, refer to the same section of the Service Manual men-
tioned in FOREWORD of this manual.
1. Front drive shaft (LH)
2. Oil pan
SECTION 7B
LINE PRESSURE TEST
LINE PRESSURE SPECIFICATION
Engine s eed Engine speed
(2500 – 2900
Special Tool
(A): 09925-37810
D range
260 – 460 kPa
Idling speed 2.6 – 4.6 kg/cm
40.0 – 65.4 psi
Stall speed 660 – 850 kPa
6.6 – 8.5 kg/cm
r/min) 93.9 – 120.8 psi
AUTOMATIC TRANSMISSION (3 A / T) 7B-1
Line pressure
R range
660 – 900 kPa
2
6.6 – 9.0 kg/cm
93.9 – 127.9 psi
Over 1,330 kPa
2
Over 13.3 kg/cm
Over 189.2 psi
2
2