Ezgo EXPRESS L4 Technician's Repair And Service Manual page 100

ENGINE
Read all of Section B and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
B
A1
Fig. 14 Starter/Generator Wire Connections
FROM TO
A1 Ground
A2 Terminal F1 on Starter/Generator
F1 Terminal A2 on Starter/Generator
F2 Terminal A on Solenoid
DF Green wire to Voltage Regulator
Fig. 15 Starter/Generator Wiring
COOLING SYSTEM CLEANING
At least once a year, or more often under adverse condi-
tions the cooling system should be cleaned. Cleaning
will assure an adequate supply of air to the cooling fins.
Compressed air may be used for routine cooling system
maintenance (Ref. Fig. 16).
Operation in wet or damp weather or overly fresh cut
grass may result in a variety of debris accumulating and
adhering to the internal shroud and fins of the cooling
system.
Page G-6
F2
A2
DF
Repair and Service Manual
Fig. 16 Cleaning Cooling System with Air
SPARK PLUG
Tool List
Spark Plug Socket,13/16" ............................................1
Feeler Gauge, wire type ..............................................1
Ratchet & Extension ....................................................1
Torque Wrench, ft. lbs ..................................................1
This engine uses Spark Plug NGK BPR2ES with a gap
of .028" - .031" (.70 - .80 mm). Using a 13/16" spark plug
socket or wrench, remove the spark plug at 125 hours or
semi-annually and clean and re-gap. The spark plug
should be properly gapped (Ref. Fig. 17) and replaced in
the cylinder head, tighten to the specified torque.
ITEM TORQUE SPECIFICATION
Spark Plug 16 ft. lbs. (22 Nm)
Spark Plug
Fig. 17 Gapping the Spark Plug
Fouled spark plugs are indicated by a wet, black appear-
ance. This could be caused by a dirty air filter element or
other restrictions in the air intake system. Incorrectly
0.7 - 0.8 mm
(.028" - .031")
Gap
Qty.