Foot Pedal Adjustment; Floor Pan Removal & Installation; Neutral Adjustment - Simplicity Cobalt Series Operator's Manual

To set the cutting height at 5" (12,7 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal forward until it locks into the 5" (12,7 cm) position.
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 5" (12,7 cm) while cutting.

Foot Pedal Adjustment

The deck lift foot pedal can be adjusted to accommodate the
operator's height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 47) from the pedal
mount tab (B).
47
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the
proper orientation as shown in Figure 47.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the retaining hardware (A, Figure 48)
that secures the floor pan to the frame of the unit.
34
48
2. Tilt the back end of the floor pan up and then remove it
from the unit.
3. To re-install the floor pan: Reverse the removal
procedure.

Neutral Adjustment

The neutral system for this mower consists of two neutral
linkage rods and a pivot that connects the ground speed
control lever to the transmission. The lower rod that connects
the transmission to the pivot is factory preset and should not
be changed for neutral adjustment purposes. The adjustment
is achieved by changing the length of the upper rod (A,
Figure 49) that connects the ground speed control lever to the
pivot.
49
Determining if Adjustment is Necessary: If the zero-turn
rider "creeps" while the ground speed control levers are
locked in the NEUTRAL LOCKOUT position, then it may be
necessary to adjust the linkage rods.
Note: Perform this adjustment on a hard, level surface such
as a concrete floor.
simplicitymfg.com