Cisco IR1101 Getting Started page 13

Getting Started and Product Document of Compliance for the Cisco IR1101 Industrial Integrated Services Router

Reorient or relocate the receiving antenna.

Increase separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from which the receiver is connected.

Consult the dealer or an experienced radio/TV technician.
Caution: The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency
when using the integrated antennas. Any changes or modification to the product not expressly approved by Cisco could
void the user's authority to operate this device.
Industry Canada
Canadian Compliance Statement
Cisco® IR1101 Industrial Integrated Services Router Model
IR1101
Cisco® IR1101 Industrial Integrated Services Router PIDS

IR1101-K9
This Class A Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
This device complies with Class A Limits of Industry Canada. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Cisco® IR1101 Industrial Integrated Services Routers are certified to the requirements of RSS-210. The use of this device
in a system operating either partially or completely outdoors may require the user to obtain a license for the system
according to the Canadian regulations. For further information, contact your local Industry Canada office.
This device has been designed to operate with antennas having a maximum gain of 6 dBi. Antennas having a gain greater
than 6 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Cisco® IR1101 Industrial Integrated Services Router Model
IR1101
Cisco® IR1101 Industrial Integrated Services Router PIDS

IR1101-K9
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive
93/42/EEC
The following standards were applied:

EMC-EN 301.489-1 v1.9.2; EN 301.489-17 v2.2.1
13