Aztech WL558USB User Manual page 39

All manuals and user guides at all-guides.com
2. WPS AP List: Displays the information of the surrounding APs with WPS IE from the
last scan result. The detailed information includes the SSID, BSSID, Channel, ID
(Device Password ID), Security-Enabled.
3. Rescan: Issues a rescan command to the wireless NIC to update information on
the surrounding wireless network.
4. Information: Displays the information about WPS IE on the selected network. The
detailed list includes the Authentication Type, Encryption Type, Config Methods,
Device Password ID, Selected Registrar, State, Version, AP Setup Locked, UUID-E
and RF Bands.
5. PIN Code: The user is required to enter an 8-digit PIN Code into Registrar. When an
STA is the Enrollee, you can click "Renew" to re-generate a new PIN Code.
6. Config Mode: The station serving as an Enrollee or an external Registrar.
7. Table of Credentials: Displays all credentials obtained by the Registrar. The
detailed list includes information about the SSID, MAC Address, Authentication and
Encryption Type. If STA is the Enrollee, the credentials are created immediately
with each WPS success. If STA is the Registrar, RaUI creates a new credential with
WPA2-PSK/AES/64Hex-Key and doesn't change this until switching to STA
Registrar.
8. Control items for credentials.
a. Detail: Command to obtain Information about Security and the Key in the
credential.
b. Connect: Command to connect to the selected network inside credentials.
The active selected credential is as like as the active selected Profile.
c. Rotate: Command to rotate to connect to the next network inside
credentials.
d. Disconnect: Stops the WPS action and disconnects the active link. It then
selects the most recent profile on the Profile Page of RaUI. If there are no
profiles, the driver will select any non-security AP.
e. Export Profile: Exports all credentials to a Profile.
User Manual
Page 39 of 47