Aztech WL558USB User Manual page 32

All manuals and user guides at all-guides.com
User Manual
If the intended network uses encryption other than "Not Use," RaUI will bring up the
security page and let the user input the appropriate information to make the connection.
Please refer to the example on how to fill in the security information.
When you double click an AP, you can see detailed information about that AP.
The detailed AP information is divided into three parts. They are General, WPS, CCX
information and 802.11n (The 802.11n button only exists for APs supporting N mode.)
The introduction is as follows:
1. General information contains the AP's SSID, MAC address, authentication type,
encryption type, channel, network type, beacon interval, signal strength and
supported rates.
2. WPS information contains the authentication type, encryption type, config.
methods, device password ID, selected registrar, state, version, AP setup lock
status, UUID-E and RF bandsThe information is further explained as follows :
a. Authentication Type: There are three types of authentication modes
supported by RaConfig. They are open, Shared, WPA-PSK and WPA system.
b. Encryption Type: For open and shared authentication mode, the choices of
the encryption type are None and WEP. For WPA, WPA2, WPA-PSK and
WPA2-PSK authentication mode, the encryption type supports both TKIP
and AES.
c. Config Methods: Correspond to the methods the AP supports as an Enrollee
for adding external Registrars, (a bitwise OR of values.)
Page 32 of 47
Value Value Value Value Hardware Hardware Interface Hardware Hardware Interface Interface Interface
0x0001 0x0001 USBA (Flash Drive) USBA (Flash Drive)
0x0001 0x0001 USBA (Flash Drive) USBA (Flash Drive)
0x0002 0x0002 0x0002 0x0002 Ethernet Ethernet Ethernet Ethernet
0x0004 0x0004 Label Label
0x0004 0x0004 Label Label