The Reset Menu - AirSense ModuLaser Installation Manual

Chapter 3: Configuration and Commissioning
Performing a diagnostics test
The diagnostics test is used to perform an auto-diagnostic procedure on
compatible legacy devices. Devices must be tested individually.
To perform a diagnostics test:
1. Select Test from the Main menu, and then select Diagnostics.
2. Select the legacy devices that you want to test, and then press Enter to start
the test.
The warning indicator flashes slowly to indicate test mode.
The test status is displayed as Running (test in progress) or No test (test not
supported by this device type). Once the test has been completed, it will
indicate Pass or Fail.
3. Press F3 (Exit) to return to the Main menu.

The Reset menu

Performing a system reset
Use the Reset menu to perform a system reset on a single device or the whole
installation. System events that have not been resolved will continue to be
reported after reset.
Caution: Investigate all fire alarms and faults before resetting the system.
To reset the detection system and clear system events:
1. Select Reset from the Main menu, and then select List of Devices or All
Devices.
Selecting List of Devices allows you to select specific modules to reset.
Selecting All Devices resets all modules on the loop.
2. Press Enter to reset the selected devices.
After the reset completes, the home screen is displayed.
Note: Disablements and tests are not terminated by a reset.
52 ModuLaser Modular Aspirating Smoke Detector Installation Manual