The Device Settings Menu; The Detection Settings Menu - AirSense ModuLaser Installation Manual

Chapter 3: Configuration and Commissioning
To configure screen properties:
1. Select General Settings from the Main menu, and then select Screen
Properties.
2. Select the option that you want to configure, and then enter your changes.
3. Press F1 (Save) to save your changes and exit to the previous screen.
4. If you have no other configuration changes to make, then press F1 (Apply)
from the Main menu or the submenu to apply the changes to the system.

The Device Settings menu

Use the Device Settings menu to view device information.
Viewing device details
Use the Device Details menu to view details of the devices in the network or
cluster.
Note: Command display modules display devices for the entire SenseNET
network. Standard display modules only display devices in the associated
cluster.
To view device details:
1. Select Device Settings from the Main menu, and then select Device Details.
A list of devices is displayed.
2. Select the device that you want to view or press F1 (Go To) to search for a
device by the device address.
The device type details are displayed.
3. Press F2 (Cancel) twice to return to the Device Settings menu.

The Detection Settings menu

Use the Detection Settings menu to compare a previously saved detector status
baseline with the current detector status. See "Configuring a detector status
baseline" on page 67 for more information.
Note: Command display modules display devices for the entire SenseNET
network. Standard display modules only display devices in the associated
cluster.
To view the baseline comparison:
1. Select Device Settings from the Main menu, and then select Detection
Settings.
2. Select Baseline, and then select View Baseline.
A list of detectors is displayed.
46 ModuLaser Modular Aspirating Smoke Detector Installation Manual