AirSense ModuLaser Installation Manual page 35

Connecting to a fire alarm control panel
Note: Because of the many available options for connecting to a fire alarm
control panel, the following covers only the most common methods that are likely
to be used.
The detector provides the following options for interfacing with fire alarm control
panels:
• Inputs and outputs:
on the module to an input on the fire panel to send event notifications to the
fire panel. The module output and control panel input require appropriate
configuration.
• Addressable Protocol Interface Cards (APICs):
installation of an optional APIC board (not supplied). With the APIC board
installed and the addressable loop connected to the APIC connector on the
backplane PCB (display modules only), the detection system becomes an
additional device on the addressable loop.
See Appendix A "APIC installation" on page 91 for more information on installing
an APIC board.
ModuLaser Modular Aspirating Smoke Detector Installation Manual
This option allows (for example) connecting an output
Chapter 2: Installation
This option requires the
29