Carefree of Colorado MARQUEE Service Manual page 8

M
ARQUEE
11. Route the new motor wire into the coach and attach (refer to wiring diagram on page 7 or if the wires
were cut, splice the new wires to the existing wires. Ensure that the wire colors match (i.e. red to red
and black to black). Use a quality silicone sealant to seal the wire hole into the coach.
NOTE: If splicing the wires, allow enough lead wire from the motor so that the completed
splices can be pushed into the wall before sealing. There is not clearance room in the
case for the wires and splices.
12. Attach the end cap to the case.
13. Remove the roll bar support.
14. To test, restore power then extend and retract the awning.
15. After replacing the motor, it will be necessary to adjust the motor limits. Follow the procedure on page 7.
6
Service Manual Carefree of Colorado
052549-301
Table of Contents