SSANGYONG KYRON 2005.10 Manual page 574

AIR BAG SYSTEM
1. REMINDER FOR AIR BAG RELATED COMPONENT
REPLACEMENT
- When an air bag deploys (curtain air bags and seat belt pretensioners included), the air
bag unit must be replaced. Please do not attempt to delete the failure code with scan-100
because some data about the deployment situation are stored in the unit.
- The air bag related components, especially the air bag unit, must be stored in a sealed
case to prevent any damage.
- Please do not connect a tester to any air bag connector or single item to measure the
supplied power or resistance.
The detonator may explode due to a sudden extra power supplied by the tester.
- Before removing or installing any air bag related components, disconnect the negative
battery cable.
Collision sensors, a kind of impact G (acceleration) sensor, detect the front and longitudinal
collisions and determine whether or not the air bags are deployed. The roles of each collision
sensor are as below :
Front G sensors (inside the air bag unit)
▶
- Send signals to the front air bags and the driver's and front passenger's seat belt
pretensioners.
- By the signal from this sensor, front air bags (driver's and passenger's air bags) deploy
and the seat belt pretensioners of the driver's and passenger's seat belts retract seat
belts.
▶ Curtain air bag G sensors
- These are located inside the left and right B-pillar panel bottoms. When collision occurs,
the air bag at the side of collision deploys accordingly. Please pay attention to that, in the
case of the curtain air bag, only the air bag at the side of collision deploys, not both.
02-3
8810-03
8810-03
AIR BAG
KYRON 2005.10