Lift Cylinder Removal, Installation - Linde H 50 D Service Training

Service Training
4.8.2

LIFT CYLINDER REMOVAL, INSTALLATION

- Start the engine, operate the lift hydraulics and raise the fork carriage (8) approx. 1 metre.
- Pry out the retaining ring (1) of the cylinder to be removed.
- Block up the inner upright (2), operate the lowering control lever until the inner upright is supported by
the block and continue to operate the lever until the piston rod of the cylinder to be removed is fully
lowered.
- Disconnect the hose (6) at the base of the cylinder.
- Remove the bracket (4) on the outer upright (3).
- Tilt the cylinder (5) slightly to the side, sling a rope around the cylinder and lift the cylinder out of the mount
(9) with a suitable hoist (crane or fork truck).
- Installation is the reverse of removal.
- Bleed the cylinder when taking the truck into operation.
4.8
Section
3
Page