Volkswagen Golf 1999 Service Manual page 2234

Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
If the vehicle is not secured, there is a risk that it may
slip off the hoist.
- Remove plugs from trailing arm - 3 - and tighten
tensioning strap .
1 - Support arm of lifting platform
2 - Tensioning strap T10038 ; The vehicle must be fastened
with the tensioning straps on left and right side.
Tightening bearing bracket is only possible, when the
measured value - a - from middle of wheel hub to lower
edge bordering wheel housing is reached.
- Turn wheel hub until one of the holes for the wheel bolts is
at the 12 o'clock position.
- Install wheel hub support T10149 with a wheel bolt.
- Raise wheel bearing housing using engine/transmission
jack until dimension - a - is reached.
Caution!
Do not raise or lower the vehicle if the
n
engine/transmission jack is under the vehicle.
Do not leave engine/transmission jack under the
n
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
Página 43 de 44
12/2/2005