Sargent and Greenleaf Comptronic 6124 Management Manual

Comptronic 6124 and 6125 Electronic Safe Locks
Sargent & Greenleaf Comptronic 6124 and 6125 Electronic Safe Locks
S F
TANDARD EATURES AND

1. About Your Lock

2. The Master Code

3. Creating a Supervisor Code

4. Creating User Codes
5. Changing Codes
6. Deleting Codes
7. Detecting Active User Positions
8. Management/Employee Access
9. Time Delay
A. Opening Window Duration
B. Time Delay Duration
10. Changing The Batteries
O
PTIONS
11. Keypad Tamper Indicator
12. Duress Indicator And Investigation
13. Event Audit Trail
1. About Your Lock
Each time you press a number, letter, or other character on the keypad of your
Comptronic 6124 or 6125 electronic safe lock, it beeps and the red LED flashes.
If it doesn't, check your batteries to make sure they are fresh and/or connected
properly, then try again. (See Section 10, Changing the Batteries.)
•
The lock responds with various beep ( ) sequences to indicate different
conditions. The
•
When programming, you enter new codes twice, to confirm their accuracy.
•
If you hear an error beep (long continuous) during any programming sequence, start the sequence
over.
•
Always wait for each set of beeps to end before entering another number or letter, or you will
interrupt the code sequence.
PIN Positions
Each code created for use in your lock is assigned a personal identification number (PIN) position. The
Master Code is PIN 0 (zero), the Supervisor is PIN 1, Users are PINs 2 through 8, and the Time Delay
Override Code uses PIN 9.
2. The Master Code
The Master Code is used when entering commands for specific lock management functions. Once the
Management Reset Code (MRC) parameter has been set (see Setting Up the Lock, #630-438), you
need to change the Master Code (from the factory-set 1 2 3 4 5 6 or other Master Code). To create a
new 6-digit Master Code, enter it where the example says New MC:
2 2 * [Current MC] #
For example, to change the factory-set Master Code to 654321:
2 2 * 1 2 3 4 5 6 #
3. Creating a Supervisor Code
Using the Master Code, you can create a supervisor level code (PIN 1). The Supervisor Code can be
used to manage the user codes; it can add and delete User Codes, and enable and disable the lock
operation in Management/Employee Access (see Section 8). Make up a 6-digit Supervisor Code and
enter:
7 4 * [Master Code] #
8 Sargent & Greenleaf, Inc. 1998
F
UNCTIONS
S F
TANDARD EATURES AND
symbols in examples show the number of beeps you hear.
[New MC] #
6 5 4 3 2 1 # 6 5 4 3 2 1 #
1 # [Supervisor Code] #
Management
Multiple User
F
UNCTIONS
[New MC] #
[Supervisor Code] #
Page 1
Management Guide, Multiple User
Guide
Factory-Set
Master Code
1, 2, 3, 4, 5, 6, #
630-436