Sargent and Greenleaf Comptronic 6124 Management Manual

Comptronic 6124 and 6125 Electronic Safe Locks
Sargent & Greenleaf Comptronic 6124 and 6125 Electronic Safe Locks
S F
TANDARD EATURES AND

1. About Your Lock

2. The Master Code and PIN Position 2

3. Creating A Supervisor Code
4. Creating User Codes
5. Changing Codes
6. Deleting Codes
7. Detecting Active User Positions
8. Time Delay
A. Opening Window Duration
B. Time Delay Duration
9. Changing The Batteries
O
PTIONS
10. Keypad Tamper Indicator
11. Duress Indicator And Investigation
12. Event Audit Trail
1. About Your Lock
Each time you press a number, letter, or other character on the keypad of your
Comptronic 6124 or 6125 electronic safe lock, it beeps and the red LED flashes.
If it doesn't, check your batteries to make sure they are fresh and/or connected
properly, then try again. (See Section 9, Changing the Batteries, for
instructions.)

The lock responds with various beep (*) sequences to indicate different
conditions. The * symbols in examples show the number of beeps you hear.

When programming, you enter new codes twice, to confirm their accuracy.

If you hear an error beep (long continuous) during any programming
sequence, start the sequence over.

Always wait for each set of beeps to end before entering another number or letter, or you will
interrupt the code sequence.
PIN Positions
Each code created for use in your lock is assigned a personal identification number (PIN) position. The
Master Code is PIN 0 (zero), the Supervisor is PIN 1, Users are PINs 2 through 8, and the Time Delay
Override Code uses PIN 9. Security Note: To maintain the security of the dual control lock, the master
code holder and the PIN 2 holder must change their respective codes and verify no other code positions
are active using 7 7 *.
2. The Master Code and PIN Position 2
The Master Code and PIN position 2 are used when entering many commands for specific lock
management functions. You must change the Master Code from the factory-set 1 2 3 4 5 6 (or other
Master Code) and the PIN position 2 from factory-set code 2 2 2 2 2 2 before you put the lock into
service.

Use this programming sequence whenever you need to create a new 6-digit Master Code. Enter
your new Master Code where the example says New MC:
2 2 * [ Current MC ] # ***** [ New MC ] # *** [ New MC ] # ***
For example, to change the factory-set Master Code to 654321:
2 2 * 1 2 3 4 5 6 # ***** 6 5 4 3 2 1 # *** 6 5 4 3 2 1 # ***

Use this programming sequence when you need to create a new 6-digit PIN Position 2 code. Enter
your new Code where the example says New Code:
2 2 * [ Current PIN 2 code ] # ***** [ New Code ] # *** [ New Code ] # ***
For example, to change the PIN Position 2 code to 646464:
2 2 * 2 2 2 2 2 2 # ***** 6 4 6 4 6 4 # *** 6 4 6 4 6 4 # ***
F
UNCTIONS
S F
TANDARD EATURES AND
Management Guide, Dual Control
Management
Guide
Dual Control
F
UNCTIONS
Factory Settings
Master Code
1, 2, 3, 4, 5, 6, #
User Code
( position 2)
PIN
2, 2, 2, 2, 2, 2, #