Programming Examples - Safeline SL2 Manual

Programming
examples -
SafeLine Auto-
dialers Units
Note! Please refer to the full
configuration setup in the
"Configurations codes table"
as these are merely examples.
Installation
Example 1. Storing of two different telephone numbers, both to
be answered as voice calls. For test facility, see example 2.
1. Start configuration:
2. 1 phone number:
st
3. 2 phone number:
nd
4. Call type 1 number:
st
5. Call type 2 number:
st
6. Alarm button delay:
7. End configuration:
Example 2. SLCC and 3 day test. (SLCC – SafeLine Call Centre)
1. Start configuration:
2. Enter P100 ID code:
3. Set test alarm type:
Set number of days
4.
between test alarm:
5. LMS phone number:
6. Test alarm:
7. End configuration:
If at any time you need to start over, use the factory reset command
*99*1#
10
SL2 v. 2.01 EN