Configuration; Parameter List - Safeline SL2 Manual

Parameter List

PROGRAMMING DATA
Enter programming mode
Enter password
Exit programming mode
ALARM CODES
P100 ID code
CPC ID code
Q23 ID code
TELEPHONE NUMBERS
1st Phone number
2nd Phone number
3rd Phone number
4th Phone number
CALL TYPE
Call type 1st number
Call type 2nd number
Call type 3rd number
Call type 4th number
Call type LMS number
TEST ALARM/BATTERY ALARM CODE DATA
LMS phone number
Test alarm
Days between tests
Test alarm protocol
ALARM CHARACTER
Alarm character 1st number
Alarm character 2nd number
Alarm character 3rd number
Alarm character 4th number
Alarm character LMS
Alarm character Test alarm

Configuration

CODE DATA
00
* - - - - #
*00*#
CODE DATA
*01* - - - - - - - - #
*02* - - - - - - #
*03* - - - - - - - - - - - - # Q23 is always 12 digits
CODE DATA
*11* - - - - - - - - - #
*12* - - - - - - - - - #
*13* - - - - - - - - - #
*14* - - - - - - - - - #
CODE DATA
*21* - #
*22* - #
*23* - #
*24* - #
*30* - #
*16* - - - - - - - - - #
*17* - - - - - - - - - #
*27* - - #
*31* - #
CODE DATA
*41* - - #
*42* - - #
*43* - - #
*44* - - #
*45* - - #
*46* - - #
11
COMMENTS
Default = 0000
COMMENTS
P100 is always 8 digits
CPC 6-8 digits
COMMENTS
Phone number to alarm receiver 0-16 digits.
If calling through a switch board, delay time
can be set by adding asterisks between
leading number of the switchboard and tele-
phone number for the alarm call receiver.
Each asterisk is equal to one second delay.
Example: *11*(0)**1234567#
COMMENTS
Change the call type for the telephone
numbers stored.
0 = P100
1 = VOICE (Default)
2 = Q23
3 = CPC
Change this only if your alarm operator is
using any of the mentioned protocols.
LMS (Lift Monitoring System) call type
0 = P100
3 = CPC (Only battery alarm)
4 = Caller ID (Battery powered only)
COMMENTS
LMS (Lift Monitoring System) phone number
to alarm receiver/SLCC.
Phone number to test alarm receiver/SLCC.
Number of days between test alarms, 00-99
days. Always two digits. Max 3 days accord-
ing to EN 81-28.
00 = No test alarms
Protocol test alarm
0 = P100
3 = CPC
4 = Phone number used as ID.
COMMENTS
Alarm character. only when using CPC as
alarm protocol normally 10 or 27 check with
your alarm company !
LMS (Lift Monitoring System) (Battery alarm)
Normally 17
Normally 26
SL2 v. 2.01 EN