Table of Contents
Advertisement
DISTRESS MESSAGE
Record distress message
played in the lift car.
Record alarm message
from Lift Car to alarm
central
Options for the recorded
distress message
Options for the recorded
message from lift car
OTHER CODES
End of alarm message
with voice
Emergency signal in
speaker
Ring tone timeout
Additional input
function
Additional input type
Hot Line
Compatibillity mode
Configuration
CODE DATA
COMMENTS
*51*
"Speak" # This message will be played in the lift cabin when the
emergency lift telephone starts calling the alarm centre.
Make sure that there is no noice in the background when
recording the message. Recording will be done with the
internal microphone of the SL2.
Example of message: Please do not panic, the emergency
telephone is now calling the emergency call centre.
*52*
"Speak" # This message will be played to the alarm receiver and in
the car when the call is answered. Make sure that there is
no noice in the background when recording the message.
Recording will be done with the internal microphone of
the SL2.
Example of message: This is an alarm from the lift on
5th avenue. To hear the this message again, press "1". To
terminate the call, press "#" before hanging up.
*61*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*61*
#
Play the the recorded message.
*62*
- #
0 = Disable recorded message.
1 = Enables recorded message.
*62*
#
Play the the recorded message.
CODE DATA
COMMENTS
*70*
- #
When the end of alarm signal is given (reset) the unit will
automatically call the 1 st emergency number that enables
the technician to confirm the operator that the alarm is
ended (not possible when using the messages end of
alarm, see code *84*).
0 = without end of alarm call back
1 = call back end of alarm
*71*
- #
The speaker siren will sound at emergency call.
1 = On
0 = Off (Default)
*72*
- - #
Number of ring signals before dialling the next number.
(8 by default)
*73*
- #
Selects input function:
0 = None (Default)
1 = Filter, blocks the alarm input when active.
2 = LMS (Lift Monitoring System), sends a lift monitoring
alarm at input activation.
3 = Clear/Maintenance
*74*
- #
0 = Normally-open contact, NO (Default)
1 = Normally-closed contact, NC
*75*
- #
Phone connects directly to a fixed receipient without
dialling a phone number
0 = Standard phone line (Default)
1 = Hotline
*77*
- #
0 = Automatic voice switching. The call is validated when there is a
voice response. The call is terminated by pressing "#".
1=Kone ECII (lift telephone)
When there is a voice response, some ascending tones will be
heard. The call is validated by pressing "4". The call is terminated
by pressing "0". The call is terminated without reciept notification
by pressing "2"(the unit will call the next number).
2 = Manual voice switching. When there is a voice response, some
ascending tones will be heard. The call is validated by pressing
"4". Unit is still in automatic mode. To enter manual mode and talk
press "
"4". The call is terminated by pressing "#". It is possible to enter
manual voice switching mode although the unit is programmed as
automatic by pressing "
3 = Swiss M (Alarm operator mode)
Only to be used in voice mode. Disconnect by "0".Dials the next
number if call timeout, blocking tone, new dailing tone, and
operator silence.
12
". To listen press "7". Go back to automatic mode press
*
". No ascending tones will be heard.
*
SL2 v. 2.01 EN
Advertisement
Table of Contents
