Configuration Examples - Safeline Autodialer Units - Safeline MX3 Installation Manual

Confi guration

CONFIGURATION EXAMPLES - SAFELINE AUTODIALER UNITS

Example 1. Storing of two different telephone numbers, both to be answered as voice calls.
For test facility, see example 2.
1. Start confi guration:
2. 1 phone number :
st
3. 2 phone number :
nd
4. Call type 1 number :
st
5. Call type 2 number :
st
6. Alarm button delay:
7. End confi guration:
If at any time you need to start over, use the factory reset command *99*1#.
Example 2. SLCC and 3 day test. (SLCC – SafeLine Call Centre)
1. Start confi guration:
Enter P100 ID code:
2.
3. Set test alarm type:
Set number of days between
4.
test alarm:
5. LMS phone number:
6. Test alarm:
7. End confi guration:
If at any time you need to start over, use the factory reset command *99*1#.
Note! Please refer to the full confi guration setup in the "Parameter list" as these are merely examples.
© 2015 SafeLine and all the SafeLine products and accessories are copyrighted by law.
Lift ID code (each lift must have its own unique code).
(Only if using SLCC)
(For P100 use telephone number of SLCC, for Caller ID set
*31*4# and telephone number of GSM modem)
16
- Shown set for: voice.
- Shown set for: voice.
- Shown set for 3 seconds.
- Shown set for: P100.
- Shown set for 3 days.
MX3 v1.06 EN