Janfire Combiflame Manual page 3

Boiler for wood pellets, log and brown coal
Table of Contents

Advertisement

There will be no compensation for any costs of replacement.
Warranty will be lost if the product is not installed, set into operation,
!
maintained and handled properly.
Janfire will not give any warranty for faults concerning the hydraulic, the
!
electric installation or the flue gas system.
The boiler may not be used without adequate water pressure or without being
connected to the hydraulic - and the flue gas system.
Warranty will be lost by the use of not permitted fuel, insufficient draft, insufficient handling,
maintenance and no proper installation.
Warranty will be lost too, if changes or repairs are made without our permission.
There will be no responsibility for damages evoked by leakage water, corrosion, aggressive vapours,
dust, humidity (for example laundry dryer or washer in the boiler room), overpressure, assembly of
the boiler in areas with explosive atmosphere or damages evoked by oxygen or dirt in the hydraulic
system.
Advanced claims are excluded, especially any claim for damages, if they are not founded by law.
If a warranty claim was not justified, we will bring our costs to account.
3
Brief description / scope of delivery / allowed fuels
The usage of the Janfire Combiflame guaranties an environmentally friendly and economic operation
during heating. By the use of renewable fuels like wood pellets or log the heating is CO2-neutral.
Only the same amount of CO2 will be released to the atmosphere that the tree has collected during
its growth.
Advantages:
• good value combi boiler for heating and domestic hot water supply
• simple design and high performance
• can be used as an additional boiler to existing oil- or gas heating systems
• good isolation, causes only few thermal lost
• nominal heat output for pellets 20 kW
• only 15 Pa natural draft is needed
• easy to change from pellets into a log boiler and reverse
• easy to clean and maintain
The Combiflame is a steel boiler conform with EN 303-5. The combustion chamber consists of 5
mm sheets from ST35JR (EN10025). The outside of the pressure vessel consists of 3 mm. 100 mm
Janfire
pelletswärme
swedish quality

Advertisement

Table of Contents
loading

Related Products for Janfire Combiflame

Table of Contents