Janfire Combiflame Manual page 17

Boiler for wood pellets, log and brown coal
Table of Contents

Advertisement

start up with brow coal
To ignite the brown coal a proper bed of glow is needed. Start the boiler with log. We suggest to burn
about half a filling of log until you have a bed of glow about 7cm thick. Homogenize the bed of glow
and fill in the briquettes of brown coal as described.
refilling:
Make sure that there is stable bed of glow before refilling. In our suggestion the bed of glow should
be thick at least 5 cm. For refilling the maximal rate of fuel is 10 kg of brown coal and 7 kg of log.
Burn the fuel down to a stable bed of glow before refilling again.
Close all doors of the boiler when refilling is completed.
Always were fire proofed glows when refilling the boiler. All parts of the boiler
can be hot.
Smoke can escape into the boiler room during refill. Make sure that the room
is vented properly.
Never let the boiler without supervision when any door is opened.
Warning: Do not open the front door until you have opened the start-up flap
by pulling the lever on the right side of the boiler. After the opening of the flap
you have to wait a couple of seconds before you may open the front door!
16 Cleaning
To achieve the highest efficiency the Janfire Combiflame has to be cleaned continuously. Depending
on the used fuel and the power output cleaning might be necessary every week or even more often.
Pellets:
If you run the boiler with pellets only, the following must be considered:
1. Empty the ash pit and clean the catalytic converter every two weeks.
2. Additionally to Nr. 1 clean the burner bowl every month.
3. Additionally to Nr. 1 and 2 clean the main heat exchanger an the flue gas system two times a
year. We suggest to do this service before christmas and easter. Ask your Janfire Service to help
you with this work.
Open the burner door and remove the roof of the burner bowl. Clean the burner bowl with a hand
broom. Ash and slag which are adhere to the surface of the bowl have to be scraped out with steel
brush for example. We advice to put a little bit of water on the surface of the bowl to dissolve the
Janfire
pelletswärme
swedish quality

Advertisement

Table of Contents
loading

Related Products for Janfire Combiflame

Table of Contents