Table of Contents
Advertisement
11 Pellet burner assembly and adjustment
1. Boiler and pellet burner are not assembled at delivery!
2. The pellet burner will be placed in the bottom door of the boiler.
3. Fasten the burner by using the screw hook on the eyes of the door. The screw hooks have to
be adjusted.
Make sure that the burner flange is close to the door. No air should be sucked
!
through the gasket.
4. Check the strain of the screw hooks after 2 days. Adjust them again, if necessary.
5. Connect the plugs of the burner according to the electric plan!
The electric connection has to be made according to the local terms by an
expert.
The hose between the auger system and the pellet burner is part of the safety
system. Because of that the discharge of the auger system and the infeed of
!
the pellet burner have to be eccentric (min 20 cm). A distance in high from at
least 30 cm has to be adhered too. Only Janfire certified hoses my be used.
12 Change from pellet burner to log operation
Make sure that the burner is stopped for at least an hour before you make the
!
change! Watch out for hot burner parts and glow!
Janfire
mind. 20 cm
pelletswärme
swedish quality
Advertisement
Table of Contents
