Table of Contents
Advertisement
Janfire
pelletswärme
The firing controller has to be assembled by an expert. This has to be done
!
before the boiler is filled with water. We suggest to put the controller in place
even if you do not plan to run the boiler with logs jet.
The following must be considered:
•
Remove the hose (2) by opening the clamps on either ends of the hose.
•
Unplug the power supply of the burner and the connection between burner and auger system
and the modulation sensor.
•
Open the screw hooks and remove the burner (6). Make sure that the burner and the hose will
be stored properly.
•
The draft flap has the be put in the burner hole and bolted.
•
Connect the draft flap and the firing controller with the chain.
•
The 5 parts of the cast iron grill have to be put onto the grill frame in the boiler. There is one part
of the grill with an adapter for the front grill. This part has be put in as last.
•
Put the front grill in its adapter.
•
If you want to run the boiler with pellets again, all steps have to be done reverse.
12.1 Draft flap assembly and adjustment
Janfire 06.2011
1
2
1
2
3
4
5
6
7
3
5
6
4
Advertisement
Table of Contents
