Table of Contents
Advertisement
Janfire
pelletswärme
adhesions. About 5 ml of water are enough. To clean the pellet burner follow the instruction in the
burner manual too.
See at the description below how to clean the catalytic converter and the main heat exchanger.
Never use a vacuum cleaner to clean the burner bowl. There is a high risk of
fire because of remaining glow in the burner bowl.
log ore brown coal:
1. Depending on the fuel you use, clean the grill and empty the ash pit every day. The interstitials of
the grill have to be opened. The distance should be at least 5 cm between the grill and the ash
in the ash pit.
2. Clean the catalytic converter every week.
3. Additionally to Nr. 1 and 2 clean the main heat exchanger an the flue gas system every month.
cleaning of the grill:
Never use a vacuum cleaner to clean the grill. There is a high risk of fire
because of remaining glow.
Open the bottom door of the boiler. If necessary empty the ash pit. Put the ash pit back into the
boiler than open the front grill. Clean the grill with the delivered tools or a brush. Be careful to provide
ash to fall out of the boiler. Adhesions on the grill and on the surface of the boiler walls should be
scraped away. Empty the ash pit again.
cleaning of the catalytic converter:
Always wear fire proved glows when you remove the cartridge of the catalytic
converter. Surface and lever can be very hot.
By using the lever on the front of the cartridge drag the cartridge of the catalytic converter out of the
boiler. Be careful, the cartridge is heavy. Prevent the catalytic converter from any shock!
Janfire 06.2011
Advertisement
Table of Contents
