Table of Contents
Advertisement
Clean the surface of the catalytic converter with a mellow brush. Use a vacuum cleaner to suck out
the dirt in the converter ducts.
Never use compressed air to clean the catalytic converter.
Put the cartridge back into position.
cleaning of the main heat exchanger:
Remove the catalytic converter out of the boiler.
Remove the sart-up flap. Hook of the lever. Now you can lift up the flap and drag it out of its bearing.
If the flap stuck into its bearing you can free it with some easy beats of a hammer.
Depending on the type of boiler there are vortex generators in the ducts of the heat exchanger.
Remove them before cleaning.
Clean the ducts of the heat exchanger with the delivered tools, a brush or a vacuum cleaner. If
necessary clean the flue gas pipes from the boiler to the chimney too.
17 Advice to averting of a danger
To reduce risk you have to follow all instructions of this manual everytime
!
you use this boiler.
autumn and spring:
The natural draft of the chimney depends on the temperature outside. If the temperature outside is
higher than 10°C the natural draft can be too week to run the boiler. Contact your chimney cleaner.
problems with draft:
Problems with natural draft of your chimney can cause in the location of your building. If your building
is located in a valley or in a very windy area, the natural draft of your chimney can be week depending
on the weather conditions. In this case it can be necessary to heat up the chimney before you can
start the boiler. Ask your chimney cleaner how to do it safe.
failure in domestic water supply:
You may not run the boiler with log or brown coal during a failure in the domestic cold water supply
because the thermal safety relief system will not work in this case. But it is allowed to operate the
boiler with pellets during that failure.
Janfire
pelletswärme
swedish quality
Advertisement
Table of Contents
