Disassembly And Folding Instructions - OZtrail Camper 6 Owner's Manual

Disassembly and Folding
instructions
HELPFUL HINT
OZtrail recommends two people are
required to pack away the Camper Trailer
Tent. It is a good idea to include a dustpan
and brush in your camping kit to clean the
floor before packing it away. It is also helpful
to remove any tree leaf or debris from the
roof before folding.
Step 1
Close all windows, awning and doors not needed
for folding the camper. If present, remove rear
room walls and floor as well as the front sunroom
floor and walls by following the reverse order
of the assembly instructions. Lay them on the
ground and fold in half, third or quarters. The
width of the folded sunroom floor or walls
should be the length of their carry bag, as
indicated in Figure 28.
Fold tent into a
rectangular shape
The width of the tent
should not exceed the
length of the pole bag
Front of tent
(door
unzipped)
Figure 28
Step 2
Release and remove any spreader poles #5 and
#55 (with "C" clips at each end) that have been
used to brace the awning and the main frame.
Release and remove any window poles #66 and
upright support poles #4 and #44 that were used.
Place the poles into the pole carry bag. Release
the Posibrace Velcro tab points that attach the
awning roof to the poles.
23
Step 3
Inside the Camper Trailer Tent, replace the front
side door poles into the hub plate on the bed
base making sure they are properly clipped into
place and undo the zips in the vinyl wall adjacent
the hub plates.
Step 4
Remove all guy ropes and tent pegs with a claw
hammer or peg puller and put them into their
bag.
Step 5
Collapse the awning frame by removing and
disassembling the poles in the reverse order of
the assembly instructions. Place the poles in the
pole carry bag and tie shut.
Step 6
Fold the awning back over the top of the main
Camper Trailer Tent.
HELPFUL HINT
Use a ridge pole with the hooked spigot
placed into the corner eye of the awning to
raise the awning roof up and carefully draw
it over the top of the Camper Trailer Tent. Do
this slowly to avoid snagging the awning
roof and causing any damage.
Step 7
For Camper 7 only, release the tension bolt on
the forward side poles and remove the forward
side poles and place these poles into the pole
carry bag. The forward ridge pole can remain in
the pole sleeve, as indicated in Figure 24, from
the previous Set up and Assembly Instructions
section.
Release the tension bolt on the front side/door
poles and allow the telescopic poles retract to
their minimum length. Allow a portion of the
door to remain unzipped to allow air trapped in
the Camper Trailer Tent to escape during folding.