Display Button Function; Setpoints; Setting The Time Of Day; Override Button - Siemens REV100 Manual

'LVSOD\ EXWWRQ
IXQFWLRQ
Automatic storage
Adjusting the values
6HWSRLQWV
$GMXVWLQJ WKH
VHWSRLQWV
:DUPHU / FROGHU
6HWWLQJ WKH WLPH RI GD\
6ZLWFKLQJ SRLQWV
Standard values
Changing the switching
points
2YHUULGH EXWWRQ
+ROLGD\ SURJUDP
Siemens Building Technologies
Landis & Staefa Division
Not highlighted and no symbol: function cannot be selected.
Highlighted , symbol visible: function can be selected but is not yet acti-
vated.
Highlighted , symbol / angle bar visible at top left: function is activated.
When an adjustable display button is pressed, the displayed value will automatically be
stored 5 seconds later and the previous operating mode will be resumed or reactivated.
Pressing one of these buttons for less than one second produces a step of one
minute (time settings) or of 0.2 °C (temperature settings).
Pressing for more that one second means quick adjustment which can be cancelled
again by pressing the button repeatedly.
Standard value
20 °C
16 °C
5 °C
The setpoints of and
Press the temperature button and then the required operating mode button.
. Press
mode.
Press the temperature button and then
perature in increments of 0.2 °C (max. ±4 °C) to the room temperature temporarily re-
quired. The warmer , colder function can be applied to all three temperature setpoints,
but the values thus changed will be reset again when the next switching point is
reached.
Press the time button and then
The two switching points for the 24-hour operation with one heating period and the four
switching points for the 24-hour operation with two heating periods can be entered
individually and independently.
Operating Switching
mode point 1
Ã
06:00
07:00
Press or
and select the individual switching points by pressing the respective
switching time button
.
pressing
• If two switching times coincide on the same switching time button, the display alter-
nates between the two switching points when pressing the button repeatedly
Manual changeover from the normal to the economy temperature, or vice versa.
The selection will automatically be reset when the next switching point is reached or
when changing the operating mode.
Manual changeover to the normal temperature is active
Manual changeover to the economy temperature is active
When absent for a longer period of time, it is possible to switch manually to the econ-
omy temperature and to enter the period of absence.
Room temperature controller REV100
Setting range Setting range with setpoint limitation
3...29 °C
3...29 °C
3...16 °C
are identical in both 24-hour operating modes.
to adjust the setpoint temperature of each operating
to set the correct time of day.
Switching
point 2
Ã
09:00
23:00
. Then, change the displayed switching time by
16...29 °C
16...29 °C
3...16 °C
to readjust the displayed tem-
Switching Switching
point 3 point 4
à Ã
17:00 22:00
CE1N2211en
3/8
16.05.2000