Maple Systems HMI5043L Installation Manual page 3

HMI5000L Installation Guide
Technical Support
This manual is designed to provide the necessary information for trouble-
free installation and operation of the HMI. For assistance, please contact
Maple Systems as follows:
•
Phone: 425-745-3229
•
Email: support@maplesystems.com
•
Web:
Installation of HMIs
Information furnished by Maple Systems is believed to be accurate and
reliable. However, no responsibility is assumed by Maple Systems for the
use of this information, or for any infringements of patents or other rights
of third parties which may result from its use. No license is granted by
implication, or otherwise, under any patent or patent rights of Maple
Systems. Maple Systems retains the right to revise or change its
products and documentation at any time without notice.
CE Compliance
The HMIs have been tested to conform to European CE requirements,
which meet or exceed the noise emissions and immunity requirements
as set forth in the EN55022 (Emissions) and EN55024 (Immunity)
standards. The products are designed to withstand electrical noise in
harsh industrial environments. They also conform to requirements that
limit electrical emissions. However, this does not guarantee that the
products will be totally immune from possible malfunction in cases where
severe electrical noise occurs. Therefore, follow these guidelines for
proper wire routing and grounding to ensure the proper operation of the
HMI.
NEMA Rating
The HMI is rated for NEMA 4 (indoor) or IP65/IP66 installations. This
means that when the HMI is properly mounted to a NEMA 4 panel or
other NEMA 4 rated enclosure, the front enclosure of the HMI will
provide protection to the inside of the panel from splashing water, wind-
blown dust, rain, or hose-directed water. The HMI must be installed
according to the instructions in this manual to be properly sealed.
1010-1018 Rev 10
www.maplesystems.com
www.maplesystems.com
3