Maple Systems HMI5043L Installation Manual page 11

HMI5000L Installation Guide
Ethernet
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
In order to download a project to the HMI over Ethernet, the HMI must be
assigned a unique IP address that is on the same subnet as the
development PC. For more information on Ethernet configuration
options, please refer to the EasyBuilder Pro Programming Manual.
Follow these steps to enter the System Settings menu and assign the
HMI an IP address:
1. Apply power to the HMI.
2. Click the arrow icon located in the lower-right corner of the screen.
3. Click the gear icon to enter the system settings menu.
4. When prompted, enter the system password (default: 111111).
5. Navigate to the Network* tab.
6. Enter the desired IP address, or select Obtain an IP Address
Automatically to enable DHCP.
7. Click Apply to save the changes, and OK to exit the system settings
menu.
8. The updated IP address will appear in the system information
window, also accessed via the arrow icon.
*Note: HMI5043DL, HMI5070DL and HMI5097DXL models have a
separate tab for each Ethernet port, labeled LAN1 and LAN2. See
page 16 for port information and networking configuration.
1010-1018 Rev 10 www.maplesystems.com
11