Indoor Unit Installation Drawings - Daikin R410A Series Installation Manual

Indoor Unit Installation Drawings

A
Mounting plate
Front panel
50mm or more
from walls (on both sides)
B Titanium apatite deodorizing
filter (2)
Class 20/25/35:
Titanium apatite deodorizing filter
Class 50/60/71:
Titanium apatite deodorizing filter
English
Mounting plate
The A mounting plate
fixing screw
should be installed on a
(field supply: M4 x 25L)
wall which can support the
weight of the indoor unit.
30mm or more from ceiling
Screws
M4 × 16L
Air filters
Front grille
How to attach the indoor unit
Hook the hooks of the bottom frame
to the A mounting plate.
If the hooks are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the hooks. If it is difficult to
release, remove the front grille.
Appearance of
indoor units may
differ from some
models.
Service lid
The service lid is removable.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid horizontally in
the direction of the arrow.
3) Pull down.
C Wireless remote
controller
Fixing screw for remote
controller holder
(field supply: M3 x 20L)
A
Mounting
plate
Hook
Bottom frame
Mark (rear side)
Caulk
pipe hole
gap
with putty.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the
D remote controller
holder to the wall, make
sure that control signals
are properly received by
indoor unit.
D
Remote
controller holder
6