Indoor Unit Installation; Installing The Mounting Plate - Daikin R410A Series Installation Manual

Indoor Unit Installation

WARNING
• Only use accessories, optional equipment and spare parts made or approved by DAIKIN.
• Installation shall be done by an installer, the choice of materials and installation shall comply with the applicable legislation.
In Europe, the EN378 is the applicable standard that shall be used.
1.

Installing the mounting plate

• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points
on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and dimensions
Class 20/25/35:
Place the pipe port cover
in this pocket.
Class 50/60/71:
122
56.5
7
Recommended mounting plate
retention spots (7 spots in all)
117
48 170
337
The removed pipe
port cover can be
kept in the mounting
plate pocket.
Recommended mounting
plate retention spots
(5 spots in all)
Liquid pipe end
PIPING HOLE
CENTER:170mm
TO THE LEFT
Gas pipe end
170
475
Place a leveler
on these tabs.
213 237
A
Gas pipe end
50
337
Liquid pipe end
770
Removed pipe
port cover
Place a leveler
on these tabs.
60
990
Through-the-wall
hole Ø65
Drain hose position
116.5
170 48
Use a tape measure
as shown.
Position the end of
the tape measure at
A
Mounting
plate
121.5
PIPING HOLE
CENTER:170mm
TO THE LEFT
A
170
404
.
Through-the-wall
hole Ø65
Drain hose
position
56.5
English