Sony 4-183-746-11(1) Operating Instructions Manual page 52

9
Press the Fn button.
10
Set the shutter speed and aperture.
• The shutter speed is calculated as follows to suit the selected flash
frequency and number of flashes.
Number of flashes (TIME) ÷ Flash frequency (Hz) = Shutter speed
For example, when ten flashes and 5 Hz are selected, 10 ÷ 5 = 2 requires a
shutter speed of longer than two seconds.
11
When the flash is fully charged, press the shutter
button to take the photo.
• The distance at which the proper exposure is obtained with a single flash is
displayed on the LCD panel.
• To prevent shaking, the use of a tripod is recommended during multiple
flash photography.
• Test flash will flash at the selected frequency/number/level while the TEST
button is being pressed if [TEST1] is selected in the custom setting. When
[TEST3] or [TESTM] is selected, the flash three times or the four second
modeling flash has priority.
• The use of custom settings allows the camera to be set up for multiple flash
photography without selecting the M mode (page 74).
52