Motor Flash Codes - Pentair Sta-Rite EcoSelect Enviromax 800 Owner's Manual

► If a fault develops with the motor, the error light will flash a number of times as per the following
table. Faults can be cleared by resetting power to the motor. If faults persist contact your Pentair
service agent.

Motor Flash Codes

1 2
Microcontroller Mains under
failure voltage
Microcontroller The mains
is continually voltage has
rebooting. dropped
below
180VAC.
Troubleshooting
The variable speed motor is a sophisticated and highly technical device. Should a fault
occur with the motor, it cannot be serviced and must be replaced by a certified Pentair
service agent.service agent or similarly qualified personnel in order to avoid a hazard.
Warranty is void if unauthorised modifications are made to any component.
No. of flashes
3 4
Over Over
Temperature Current
Motor Over current
temperature protection
has exceeded has tripped.
maximum Speed will
limit. reduce until
Speed will motor
reduce returns
until motor to
returns to acceptable
acceptable condition.
temperature.
5 6
Mains over Output shaft
voltage seized
The mains Motor shaft
voltage seized due
has risen to to blockage
above in pump
269VAC or fan.
7 8
Self check Motor
failed fault
One or more One or more
of the of the phases
self-tests has become
failed during disconnected.
start up or
while
running.
14