Advantech ICR-3211 Start Manual page 6

4. Ethernet
An Ethernet cable may be connected to the ETH0 connector on the front panel of the router
(see Figure above). By default, the Ethernet port is configured as follows:
Connector Purpose
ETH0 LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
Configuration
1. Configuring the Device Using the Web Browser
You can access the router for status monitoring, configuration, and administration after
entering the IP address of the router into a Web browser. The default IP address is 192.168.1.1
(netmask 255.255.255.0). Configuration access is allowed for the user "root" with the initial
password "root". Attention, it is necessary to use HTTPS protocol for secure communication
over a network! For a detailed description and examples of the router configurations, see the
Configuration Manual.
User
root
After logging on to the device for the first time, we strongly recommend to change
the default password due to security reasons.
2. Configuration Settings via SmartWorx Hub
If your router has been pre-installed with the SmartWorx Hub client, you may configure it
from SmartWorx Hub. Navigate your browser to:
If this is your first time, please register with the site. If not, please login with your username
and password. Once logged in, further assistance can be found here:
https://hub.bb-smartworx.com/Login/Help?HelpFile=bbdms_help.pdf
QSG-0006-EN, December 10, 2018
Default Password
root
https://hub.bb-smartworx.com
5
Start Guide
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
Released in the Czech Republic