Siemens Simatic Ident Function Manual page 65

Parameter
EPCID_UID
IDENT_DATA
With RF300 first generation with the attribute "0x83" the values can only be queried with ISO
1)
transponders. With RF300 second generation with this attribute the values can be queried with all
transponder types. In "General Mode" only this attribute functions.
SLG D10S only
2)
Results
Note that the UDTs can only be displayed when the blocks "Reader_Status" or "Tag_Status"
are used.
Table 3- 46 ATTRIBUTE "0x04" ("IID_TAG_STATUS_04_RF300" data type)
Name
reserved
status info
UID
MDS type
Lock state
Reserved1
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
Data type
Array[1...62] of
Byte
Any / Variant
Type Comment
BYTE
BYTE MDS status mode
ARRAY [1..8]
of BYTE
BYTE Type of MDS
BYTE Write Protection Status EEPROM
ARRAY[1..6] of
BYTE
Default values Description
0 Buffer for up to 62 bytes EPC-ID, 8
bytes UID or 4 bytes handle ID.
2 - 62-byte EPC-ID is entered at
•
the start of the buffer (length is set
by "LEN_ID")
8-byte UID is entered at the start
•
of the buffer ("LEN_ID = 8")
4-byte handle ID must be entered
•
in the array element [5]-[8]
("LEN_ID = 8")
Default value: 0x00 ≙ unspecified
single tag access (RF620R, RF630R)
0 Event values depending on attributes
Note:
You create either an "Array_of_Byte"
or a variable with one of the following
data types.
Other data types / UDTs can also be
created for "Any".
Setting parameters for blocks
3.4 Programming Ident blocks
65