Siemens Simatic Ident Function Manual page 59

Results
Apply the correct data type that is assigned to the ATTRIBUTE value at the "IDENT_DATA"
input of the block so that the data can be correctly interpreted.
Note that the UDTs can only be used when the blocks "Reader_Status" or "Tag Status"
used.
Table 3- 37 ATTRIBUTE "0x81" (data type "IID_READSTAT_81_RF2_3_U")
Name
status info
hardware
hardware version
loader version
firmware
firmware version HB
firmware_version_LB
driver
driver version
interface
baud
reserved1
reserved2
reserved3
distance limiting SLG
multitag SLG
field ON control SLG
field ON time SLG
sync SLG
status ant
stand by
MDS control
Table 3- 38 ATTRIBUTE "0x84" (data type "IID_READSTAT_84_MOBY_U")
Name
status info
number MDS
UID
Table 3- 39 ATTRIBUTE "0x86" (data type "IID_READSTAT_86_RF300")
Name
status info
FZP
ABZ
CFZ
SFZ
CRCFZ
BSTAT
ASMFZ
reserved0
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04
Type Comment
BYTE SLG status mode
CHAR Type of hardware
WORD Version of hardware
WORD Version of loader
CHAR Type of firmware
BYTE Version of firmware
BYTE
CHAR Type of driver
WORD Version of driver
BYTE Type of interface (RS 232/RS 422)
BYTE Baudrate
BYTE Reserved
BYTE Reserved
BYTE Reserved
BYTE Distance limiting of SLG
BYTE Multitag SLG
BYTE Field ON control
BYTE Field On time
BYTE Synchronization with SLG
BYTE Status of antenne
BYTE Time of standby after command
BYTE Presence mode
Type Comment
BYTE SLG status mode
BYTE Range 1..24
ARRAY [1..24]
of DWord
Type Comment
BYTE SLG status mode
BYTE Error counter passive: distortion without communication
BYTE Dropout counter
BYTE Code error counter
BYTE Signature error counter
BYTE CRC-error counter
BYTE Status of last command
BYTE Error counter for host interface (ASM)
ARRAY [1..17]
Setting parameters for blocks
3.4 Programming Ident blocks
59