Delete A Favorite Channel; Select A Weather Channel; Dual/Tri Watch Scan - NorthStar NS100 SS Quickstart Manual And Reference Manual

Delete a favorite channel

Select a weather channel

This option is only
available with the USA
or Canadian channel
banks.

Dual/Tri watch scan

Press 3CH to display the first favorite channel.
Repeat the procedure, if necessary, until the
favorite channel that you want to delete is
displayed.
With the favorite channel displayed, hold down
3CH for about two seconds until the radio asks:
DELETE CHxx?
Press WX to tune to the most recently used
weather channel. WX is displayed on the LCD
screen.
Press ^CH/SELv to tune to a different weather
channel, if desired.
If a weather alert is transmitted on 1050Hz
by a weather station, the radio picks it up
automatically and sounds the loud weather alert
warning tone.
You can use the radio setup menu to select
DUAL or a TRI watch mode. (See Reference
Section 1 - Select dual or triple watch mode.)
Dual watch mode will automatically scan
between the working channel and CH16 (the
priority channel).
When you are on a working channel, just press
SCAN to start scanning. DUAL WATCH is
shown on the LCD screen.
If the USA or CAN channel banks are selected,
and you have set the weather alert facility to
If you press >ENT to confirm, the channel is
deleted from your favorite channel selection.
Press any key while the loud alarm is sounding
to cancel the warning tone and listen to the
weather alert voice message.
When you are finished using the weather
channel, press WX again to return to previous
working channel.
ON, the weather channel is also scanned.
If a signal is received, scanning stops at that
channel and BUSY appears on the LCD screen.
Scanning starts again four seconds after the
BUSY annunciator disappears.
To stop at the current channel and cancel the
scan mode, press SCAN again or <ESC.
19