Blender Does Not Operate When A Setting Is Selected; Blender Stops While Blending - KitchenAid 5KSB5070 Manual

TROUBLESHOOTING

Blender does not operate when a setting is selected

Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.

Blender stops while blending

• Power Loss – Rotate selection dial to
the "OFF/O" position and then rotate
to desired selection setting and press
START/PAUSE.
• The Blender automatically shuts off after
approximately 2 minutes of blending
on Variable Speed. To reset it, turn the
selection dial to the "OFF/O" position,
and then back to your desired setting, and
press START/PAUSE.
If the problem cannot be fixed with the steps provided in this section, contact an authorised
service centre.
16
• If the LED is flashing on/off in rapid bursts,
the pitcher might not be fully in place or
the Blender might have gone into "sleep
mode" and need to be reset to "OFF/O".
Follow the "Error mode" instructions.
• Check to see if the Blender is plugged
into an earthed outlet. If it is, press
START/PAUSE; then unplug the Blender.
Plug it back in to the same outlet, and
press START/PAUSE. If the Blender still
does not work, check the fuse or circuit
breaker on the electrical circuit the
Blender is connected to and make sure
the circuit is closed.
• The pitcher might not be fully in place.
Ensure it is all the way in and the lid
is aligned.
• The Blender may need to be reset.
Turn it to the "OFF/O" position and back
to your desired setting.
• The Blender may be jammed. If it is
jammed, the Blender will stop running
to avoid damage to the motor. Rotate the
knob to "OFF/O", then unplug the power
cord. Remove the pitcher from the base,
and with a scraper, free the blades by
breaking up or removing the contents
at the bottom of the pitcher. To restart,
rotate the knob to "OFF/O" position and
then rotate to knob selection and press
START/PAUSE.