TrOUBlEShOOTINg
Blender does not operate when a setting is selected
No indicator lights are lit.
Blender stops while blending
All indicator lights are flashing
at the same time.
Blender turns on, but blades will not rotate
If the problem cannot be fixed with the steps provided in this section, see "Warranty
and service" section.
W10579680A_ENv8.indd 17
Check to see if the Blender is plugged into
an outlet. If it is, press the POWER button
(
) twice to turn the Blender OFF ,, then
unplug the Blender. Plug it back into the
same outlet. If the Blender still does not
work, check the fuse or circuit breaker
on the electrical circuit the Blender is
connected to and make sure the circuit is
closed.
The Blender may be overloaded or jammed.
If the Blender becomes overloaded or
jammed when blending heavy ingredients,
it will automatically shut off to prevent
damage to the motor. Press the POWER
button (
OFF , and unplug the power cord. Remove
the pitcher assembly from the base. If it's
overloaded, divide contents into smaller
batches. Adding liquid to the pitcher may
also reduce the load on the Blender. If it's
jammed, use a scraper to free the blades by
breaking-up or removing the contents
at the bottom of the pitcher.
The pitcher is not properly secured in the
locking collar, not allowing couplers to
engage. Remove pitcher from base and
fully seat into collar. Press down and rotate
gap
pitcher clockwise in the locking collar until
it clicks. This will allow the pitcher assembly
to engage the coupler. See "Assembling the
Blender" section.
) twice to turn the Blender
17
8/13/13 10:17 AM