Figure 74 C--Stand Positioning; Figure 75 Rod Assembly Positioning; Figure 76 Rod Pusher Installation - Carrier 69NT40-489-100 Series Operation And Service Manual

Figure 74 C- -Stand Positioning
3. Place C--stand on motor as shown in Figure 74. Place
crankcase on top of stand, note proper crankcase ori-
entation to motor.
4. Install Rod assemblies into opening as shown in
Figure 75.

Figure 75 Rod Assembly Positioning

5. Align rod assemblies to motor shaft key--way using
alignment pin as shown. Confirm alignment pin rests
on top of motor shaft.
6. Support motor shaft from back of motor. Install push-
er over shaft and alignment pin and onto crankcase,
secure with two screws.

Figure 76 Rod Pusher Installation

7. Carefully raise crankcase enough to remove c--stand.
8. Use a press to push rods and crankcase toward mo-
tor shell and into location. Crankcase will stop on mo-
tor shell. Remember to support the shaft during this
operation. Remove pusher and alignment pin from
crankcase.
9. Install key into keyway and retaining ring on shaft.
10.Install crankcase onto motor. Apply an anti--seize
compound to bolts and torque crankcase bolts to 20
lb--ft.
11. Install new rings as outlined in Compressor Ring
Replacement, page 122
12. Install new o--ring on crankcase cover and install
cover on crankcase. Install cover bolts to a tightening
torque of 80 lb--in.
125 T-305