Before Using The Calculator - Canon F-789SGA Instruction Manual

To select the statistical display format [4] STAT
([1] ON or [2] OFF)
[1] ON: Show FREQ (Frequency) Column in Statistical
Data Input Screen
[2] OFF: Hide FREQ (Frequency) Column in Statistical
Data Input Screen
To select the decimal point display format [5] Disp
([1] Dot or [2] Comma)
[1] Dot: specify dot format for Decimal point result display
[2] Comma: specify comma format for Decimal point
result display
To Adjust Display contrast [6]
Refer to the "Display Contrast Adjustment" section.

Before Using the Calculator

Check the current Calculation Mode
Be sure to check the status indicators that indicate the
current calculation mode (COMP, STAT, TABLE), display
formats setting and angle unit setting (Deg, Rad, Gra)
Return to initial setup
Press
calculator setup
Calculation mode
Input/Output Format
Angle unit
Display Digits
Fraction Display Format
Statistical Data Input
Decimal Point format
This action will not clear the variable memories.
Initialize the calculator
When you are not sure of the current calculator setting, you
are recommended to initialize the calculator (resets
calculation mode "COMP", angle unit "Degree", clears reply
and variable memories), and resets LCD contrast) by
performing the following key operations:
(All)
(YES)
(YES) .
8
CONT
to return the initial
: COMP
: Maths
: Deg
: Norm 1
: d/c
: OFF
: Dot