Table of Contents
Advertisement
18. Building into an optional enclosure
Figure 7 & 8 provides a drill pattern for our optional enclosure (ref. TKAUS22G).
The included adhesive front panel label can be used to mark the position of the holes to be drilled.
Position the label on the front panel and fix it temporary with tape.
Mark the center of the holes with a center punch.
Remove the label and drill the holes.
Pay attention to the correct diameter. Make sure all holes are free of burrs.
Degrease the front panel before sticking the label onto it. The label edges will need to be trimmed with a sharp cutter.
Fig. 7.0
Optional enclosure
11
Advertisement
Table of Contents
