Charging The Battery Pack Abroad - Sony Handycam HD-CX520 Operating Manual

See page 62 on charging, recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the

remaining battery indicator at the upper left on the LCD screen.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever  and remove the battery pack
.
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack. "
Notes on the battery pack and the AC Adaptor
When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure

that the (Movie)/
The /CHG (flash/charge) lamp flashes during charging under the following conditions:

The battery pack is not attached correctly.

The battery pack is damaged.

The temperature of the battery pack is low.

Remove the battery pack from your camcorder and put it in a warm place.
The temperature of the battery pack is high.

Remove the battery pack from your camcorder and put it in a cool place.
Do not short-circuit the DC plug of the AC Adaptor or battery terminal with any metallic objects. This

may cause a malfunction.
In the default setting, the power turns off automatically if you leave your camcorder without any

operation for about 5 minutes, to save battery power ([A.SHUT OFF]).

Charging the battery pack abroad

You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Do not use an electronic voltage transformer.

US
1
(Photo) lamps (p. 15), the access lamp (p. 48) are turned off.