Charging The Battery Pack Abroad - Sony HDR-CXSOO Operating Manual

us
14
• See page 62 on charging, recording and playing time.
• When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper left on the LCD screen.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever
<D
and remove the battery pack
®.
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step
1:
Charging the battery pack:'
Notes on the battery pack and the AC Adaptor
• When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure
that the
1:1
(Movie)/O (Photo) lamps (p. 15), the access lamp (p. 48) are turned off.
• The i/CHG (flash/charge) lamp flashes during charging under the following conditions:
- The battery pack is not attached correctly.
- The battery pack is damaged.
- The temperature of the battery pack is low.
Remove the battery pack from your camcorder and put it in a warm place.
- The temperature of the battery pack is high.
Remove the battery pack from your camcorder and put it in a cool place.
• Do not short-circuit the DC plug of the AC Adaptor or battery terminal with any metallic objects. This
may cause a malfunction.
• In the default setting, the power turns off automatically if you leave your camcorder without any
operation for about 5 minutes, to save battery power ([A.SHUT OFF]).