Sony HD 3CCD Operating Instructions Manual page 66

Symptom
The VISCA control is not available with
a computer connected to the camera.
The picture quality obtained from the
camera connected to a computer differs
from that from the camera connected to a
video monitor.
The camera cannot be operated at all.
66
Troubleshooting
Cause
The computer is not correctly connected to
the camera.
Depending on your computer or video capture
board, you may not be able to obtain the
expected picture quality.
—
Remedy
Make sure the connection between the
computer and camera is made correctly.
Check that the VISCA control setting (RS-
232C or RS-422) and the baud rate setting
(9600 bps or 38,400 bps) are properly made
with the BOTTOM switch on the bottom of
the camera (page 19) and the DIP switch on
the Remote Control Unit (page 23).
Try to connect the camera to the RM-BR300
Remote Control Unit to check that the camera
works properly.
Consult with your computer manufacturer or
dealer for details.
Pull out the plug of the power cord from the
AC outlet, then reinsert it into the AC outlet
after a while.