Installation; Disassembling - Microview iSERIES I30VD Quick Operation Manual

iSERIES I30VD Network Dome Camera·Quick Operation Guide

2 Installation

Before you start:
 Please make sure that the device in the package is in good condition and all
the assembly parts are included.
 Make sure that all the related equipment is power-off during the installation.
 Check the specification of the products for the installation environment.
 Make sure the power supply is matched with your required voltage to avoid
damage.
 If the product does not function properly, please contact your dealer or the
nearest service center. Do not disassemble the camera for repair or
maintenance by yourself.
 Please make sure that the wall is strong enough to withstand three times the
weight of the camera.

2.1 Disassembling

Steps:
1. Loosen the three screws on the edge of the bubble with the screw driver.
2. Open the bubble and remove the black liner as shown in Figure 2-1.
11