ultracomfort UC210 Owner's Manual page 7

Power Lift Chair Operation Models
1. To recline the back of the chair, press button (S1) and hold until the back reaches the
desired position. Then release the button.
2. To bring the back of the chair to an upright position, press button (S2) and hold
until the back reaches the desired position. Then release the button.
3. To raise the foot rest and seat, press button (S3) and hold until the foot rest reaches
the desired position. Then release the button.
4. To lower the foot rest, seat, and lift the chair, press button (S4) and hold until the
footrest closes, then release the button. If you want to lift the chair, continue holding
button until chair reaches the desired height. Then release the button.
5. To lower the chair from a raised position, press button (S5) and hold until the chair
reaches the floor. Then release the button. If you want to raise the footrest, continue
holding the button until the footrest reaches the desired position. Then release the
button. Button (S4) will also lower the chair from a raised position.
6. To lift the chair from a seated position (footrest closed), press button (S6). Continue
holding button until chair reaches the desired height. Then release the button.
7. To lift the chair with the back open (back down, footrest closed), press button (S4).
Continue holding the button until the chair reaches the desired
height. Then release the button.
8. To close and lift the chair from a reclined position (footrest
up, back down), press button (S6). If you want to bring the
chair to a seated position, hold the button until the footrest
closes, then release it. Press button (S2) to bring the back the
rest of the way up to seated position. If you want to close and
lift the chair hold down the button until the chair stops. The
motors will automatically shut off when the back closes all the
way and the chair reaches its highest position.
9. Getting into your lift chair. While standing next to your
chair, press button (S4 or S6) and raise the chair to a height
you can sit against. This height will vary from person to person
depending on the individual's needs. Raise the chair high enough
so you do not have to flop down into the chair. Flopping down
into the chair will damage it and could cause personal injury.
Press button (S3 or S5). As the chair continues downward adjust
yourself into a position that is comfortable to you. Continue holding button until chair
is in the seated position (chair firmly on the floor), then release the button. Continue
operating the chair with buttons S1 thru S6 until you reach your desired position.
10.Getting out of your chair. Press button (S4 or S6) and raise the chair to a height that
enables you to easily stand. Release the button. Return the chair to the seated position
(chair firmly on the floor) after getting out of the chair so children, pets or obstructions
do not get under the chair. Repeat no. 8 when you want to sit down.
Note: The motors are set to shut off when they reach their fully extended or fully
retracted position if the selected button is not released. If you should go past your
desired position, select the button to bring you back to your desired position. You
can repeat the process as often as you like.
UC550-S, UC550-M, UC550-L,UC620
6
S1
S3
S5
S2
S4
S6