ultracomfort UC210 Owner's Manual page 5

Making Power Connection in
Your New Lift Chair
1. Install two 9 volt alkaline batteries in the inline battery holder on the power
cable as shown for battery backup as shown.
L.E.D. light
2. Remove the transformer from the transformer box, install two 9 volt batteries
and plug the chair into a 115-120V 60Hz A.C. as shown on page 3.
3. Pull the hand control out of the magazine pocket and secure the cord into the
quick release cable clamp located above the pocket on the arm of the chair.
4. Back installation: Press the down arrow on the hand control until the footrest
is about parallel to the floor. This will expose the back brackets at the rear of
chair.
5. Slide the back down between the brackets until the threaded studs on the back
slip thru the holes in the brackets as shown.
6. Thread the flange lock nuts onto the studs and tighten securely using the
supplied wrench or a 7/16" box wrench. Return the chair to the seated upright
position by pressing the up arrow on the hand control.
7. Attach the bottom of the outside back to the Velcro on the arm cross rail.
8. Place the chair in the desired position in the room, leaving the chair a safe
distance from the wall. See chair location page 3 for the proper distance from
the wall.
9. Adjust the leg levelers on the bottom of the chair if necessary. Some high pile
carpets can obstruct the footrest operation by rubbing against it. Adjust the
levelers to a height above the pile.
Model UC540-XL
(batteries not included)
4