Table of Contents
Advertisement
Firmware Updates
If the need arises, you can replace the NBP firmware. This section covers the following
firmware-related topics:
•
•
Determining the Firmware Version
To check which firmware version the button panel is using, do one of the following:
•
•
Before using those methods, connect the NBP and the PC to the same network. For details
see the
Software-based Configuration and Control
Using Toolbelt Software
1.
2.
3.
Using a Browser
The NBP comes with a factory default embedded web page, where you can check the
firmware version as follows:
1.
2.
3.
Determining the Firmware Version
Updating the Firmware
View the device information in Toolbelt.
View the general status information section of the NBP embedded web page.
Hardware Features and Installation
Open the Toolbelt software.
Either add the desired control processor manually or start device discovery and select
the desired processor from the list of discovered devices.
Click Manage in the row for the desired control processor and view the device
information that appears in that section.
Start a browser program.
Type the IP address of the NBP into the address field of the browser and log on to the
internal web page.
Look for the general device or status information section.
section starting on page 6 and the
section starting on page 28.
Network Button Panels • Firmware Updates
36
Advertisement
Table of Contents
